(Catalogue)
1. Product Introduction ................................
2. Installation ...............................................
3. Operation .................................................
4. Common Breakdown and Disposal ............
5. Technical Data .........................................
Intelligent Solar Charge Controller
User's Manual
Please read this manual carefully before you use this product.
1. Product Introduction
This controller is a kind of intelligent multi-purpose solar charge and discharge controller.
These serial products adopt customized LCD display screen, which makes the operation on thr interface rather convenient.
All the controlling parameters can be reset flexibly to satisfy your different needs.
This controller has the following features:
Visual LCD graphic symbol
Brief key operation
Automatic identification system voltage level
Intelligent PWM charge mode
Automatic temperature compensaton
Adjustable charge-discharge control parameters
settable operating modes of loads
Accumulated charge and discharge ampere hours
Remote monitoring function (custom)
Battery reverse-discharge protection
Battery low voltage disconnection (LVD)
Battery reverses connection protection
Overload and short circuit protection
With DC 12V and USB 5V output (custom)
2. Installation
Installation:
1. Get ready the related tools and cables, We suggest you to choose the right cables,
Recommendation: 20A,30A using 16mm cable, 40A,50A,60A using 25mm cable.
Check whether the installation place accords with the relative safety requirement.
Please avoid installing and using the controller under the following conditions, damp,
dusty places or places with flammable, explosive and corrosive gases.
2. Install the controller into a fixed vertical plane. please refer to chapter 5 formore detailed
info about the spacing between the installing holes. In order to make the controller have a good
thermal condition, please spare 10cm above and below the controller.
3. As shown on the right, first you connect the (1) loads (2) Battery (3) Solar Panel with controller order.
Pay attention to connect the loads, battery, solar panel and controller of same polarity.
4. Put the external thermal sensor into the interface of thermal-sensor on the left of the controller.
The temperature sensor should be similar space with battery.
(Otherwise, the controller will control the parameters of all wrong temperature compensation.)
5. If you have remote monitoring and control function, please insert one end of the included communication wire on the right of the controller (communication port) the other end to connect to the host computer.
Demolition: To avoid the accident, please dismantle solar panels, battery and loads from the controller in order.
Attention: connecting the battery reversed will not damage the controller, but will cause safety risk on your loads.
No comments:
Post a Comment